rupture test
英 [ˈrʌptʃə(r) test]
美 [ˈrʌptʃər test]
网络 破坏试验; 断裂试验
双语例句
- Objective To compare the rupture test of soft capsules of dietary supplements with the disintegration test, and to find the correlations and differences.
目的比较保健食品软胶囊的破裂试验结果与崩解时限检查结果，了解两者的相关性和差异性。 - In this paper, the design principle of the controllable pressurized double rupture disk device and its test results are brie-fly described.
本文扼要地叙述了可控定压爆破双膜装置的设计原理和试验研究结果。 - Described here is the cold bending rupture test on the AC-16C modified asphalt mixture designed using the GTM method with varied gradation, bitumen-aggregate ratio and cement-bitumen ratio.
论述了以GTM设计的AC-16C改性沥青混合料为基础，在级配、油石比、粉油比变化的条件下，分别对混合料进行低温弯曲破坏试验。 - The Research on Safe Reliability Evaluation of 12% Cr-steel High-temprature Bolt Based on Accelerated Creep Rupture Test
基于加速蠕变断裂试验的12%Cr钢高温螺栓安全可靠性评价研究 - Experimental Investigation on Case Rupture Test of HV Shunt Capacitors and Discussion on Some Relevant Problems
高压并联电容器壳体耐爆能力试验研究的新进展及相关问题的探讨 - Rupture Analysis and material test of converter tubes for making hydrogen
制氢转化炉炉管材质破裂分析及改进措施 - Effects of carburizing time on microstructure and transverse rupture strength of cemented carbide with gradient cobalt structure fabricated by pre-sintering-carburizing process were studied by optical microscopy and transverse rupture strength test.
采用预烧结-后续渗碳的方法制备钴相呈梯度分布的硬质合金，通过对试样显微组织的观察和抗弯强度的测试，研究渗碳时间对梯度硬质合金显微组织和抗弯强度的影响。 - The paper studies the automatic detection technology for spring rupture in the test of driven disk of automotive clutch. It puts forward an automatic detection rationale, taking the change of torsion stiffness as the identification feature, and carries out the corresponding analysis and calculation.
对汽车离合器从动盘扭转耐久试验中弹簧断裂的自动识别技术进行研究，提出一种以弹簧刚度特性变化为识别特征的识别原理，进行了相关的分析计算； - The design scheme, development and adjusting method of automatic level adjusting system of lever of creep and rupture strength test machine are presented in this paper.
阐述蠕变持久强度试验机杠杆自动调平系统方案设计研制与调整方法。 - Based on the long time practice and the authors ′ experience, three basic types of similarity relationship between the prototype and the model for dynamic structural model test and dynamic rupture model test have been proposed.
通过多年模型试验的实践与体会，提出了结构动力模型试验与动力模型破坏试验中保持模型与原型相似的3种基本要求与处理技巧。 - The influence of rare earth cerium atom on the amount, morphology and distribution of the grain boundary phase of Fe-Cr-Ni-Nb-Ti-Al-W alloy was investigated, and the relationship between the above characteristics and the stress rupture lifes of the test alloys was discussed.
研究了稀土元素铈对铁基合金Fe-Cr-Ni-Nb-Ti-Al-W晶界析出相的数量、形貌、分布的影响及其与持久寿命的关系。 - Rupture test studies of the arch belly gravity dam under overloading
腹拱重力坝超载破坏试验研究 - The single leg rupture test in slam water and calm wave.
在静水和汹涛中单腿破断试验。 - Methods: Ten samples of placenta of preterm birth and premature rupture with masculine Uu ( test group) and ten normal placenta tissues ( control group) were respectively obtained and observed with TEM.
方法：取胎膜早破和早产胎盘组织标本各10例，Uu培养均阳性（试验组）；同时取10例正常妊娠胎盘组织（对照组）进行电镜观察。 - The experiment result shows that experimental data of common tests under different heat treatment temperature display no great differences, while rupture test could, which verify that the heat treatment temperature of 760 ℃ is comparatively feasible.
试验结果表明：常规力学性能在不同的热处理温度下没有反映出很大的差异，而持久强度试验则反映出经热处理材料的性能差异，试验表明760℃的热处理温度较为合适。 - Monitoring and controlling system and program for stress-rupture tester were developed according to GB/ T 2039-1997 《 Metallic Materials-Creep and Stress Rupture Test in Tension 》.
根据GB/T2039-1997《金属拉伸蠕变及持久试验方法》对高温持久试验的要求，对高温持久试验设备进行控制系统的设计和软件的开发。 - Automatic detection of Spring Fatigue Rupture in Torsion Durability Test of Automotive Clutch Driven Disk
汽车离合器从动盘扭转耐久试验中弹簧疲劳断裂的自动识别 - Different from above mentioned two methods, the rupture mode of the trapezoidal tear test is simple and the testing results are stable. Thus, this method is recommended for testing tear strength of architectural membrane materials.
梯形撕裂法的撕裂模式单纯，试验结果也较稳定，是值得推荐的膜材料撕裂强度测试方法。 - Using special electro hydraulic and hydraulic elevator experiment rig, the pipe rupture valve is completed test.
利用专门的电液元件测试平台和液压电梯台架对限速切断阀进行了比较全面的实验，拓展了新元件的实验研究手段。 - Investigation on the power Capacitor Case Rupture Test and Methods Calculating tbe pourable Energy
电力电容器外壳耐爆试验及注入能量计算方法的探讨 - It is known that non-rupture test, such as the hardness test, an be used to replace rupture tension test on iron and steel casting.
钢铁铸件用非破坏性的硬度检验代替破坏性的抗拉强度检验并在生产中应用，国内外均已有报导。 - At first, RCC rupture strength and fracture coefficient is acquired by RCC fracture test, which provides basal datum for following calculation and model test.
首先进行了碾压混凝土的断裂性能试验，获得了碾压混凝土的断裂韧度、断裂能等力学指标，为计算分析和试验研究提供了基础资料； - Results indicate that the primary cause to the rupture of the screw in the process of torque force test is proved to be heavily existence of holes and pore gaps in the screw arising from the central looseness of the original billet.
结果得出：螺钉在扭力试验过程中断裂是由于内部存在严重的孔洞和孔隙所造成的，孔洞和孔隙来源于原铸坯的中心疏松。 - The development of automatic level adjusting system of lever of rl-3/ 4 type creep and rupture strength test machine
RL3/4型蠕变持久试验机杠杆自动调平系统研制 - The creep rupture test results of ferritic/ austenitic dissimilar metal welds by nickel base alloy, austenitic and ferritic fillers show that the mismatch of creep strength between different materials is the main cause of premature failure of dissimilar metal welds during elevated temperature service.
通过用镍基合金、奥氏体和铁素体填充材料焊接的铁素体-奥氏体异种钢接头的蠕变断裂试验结果表明，材料之间的蠕变强度不匹配是异种钢接头高温运行中过早失效的主要原因。 - In this paper the rupture time of T/ P91 steel under different test conditions was calculated, using constrained cavity growth model. Results show that the ratio of calculated time to measured value is less than 2.
本文采用受约束蠕变孔洞生长模型计算了不同试验条件下T/P91钢的持久断裂时间，计算值与实测值相差不到2倍。